Electrical power UNITS FOR LIFT TABLE one
Standard Description
This electrical power unit is made solely for the smaller lift table,Consisting of large stress gear pump, AC motor, multi-functional manifold, valves, tank, etc. This electrical power unit has been extensively applied inside the marketplace of logistic gadgets including minifork lift, scissors lift and ariel doing work platforms. The lower-ing motion is managed from the solenoid valve together with the velocity controlled through the adjustable needle valve.
Power UNITS FOR LIFT TABLE 2
Common Description
This energy unit is made solely for the medium lift table, Consisting of extremely effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing motion is actived from the solenoid valve and the pace managed by the adjustable needle valve. Once the lift rises to a higher positoin, but the electrical power provide is minimize, the decreasing movement is managed from the guide override function.
Energy UNITS FOR LIFT TABLE three
Standard Description
This electrical power unit is designed solely for your massive lift table, Consisting of hugely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering motion is 
actived through the solenoid valve and also the velocity managed by a pressure compensated flow management valve.
Power UNITS FOR LIFT TABLE four
Basic Description
This power unit is created exclusively for the massive lift table, Consisting of really effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived by the solenoid valve plus the speed managed by the adjustable needle valve. When the lift rises to a large positoin, but the power provide is reduce, the lowering motion is managed by the guide override function.
Particular Notes
one. This electrical power unit is of S3 duty cycle, which may only perform intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
2. Clean each of the hydraulic parts concerned just before installation of the power unit.
3. Viscosity from the oil shoud be 15~46 cst,which must also be clean and absolutely free of impurities.N46 hydraulic oil is proposed.
4. Oil shifting is needed just after the initial 100 operation hours,afterwards once every single 3000 hrs.
five. The energy unit shown is made to be mounted vertically.
