C Form Flex-Flex Couplings
The C Style coupling consists of two flex hubs, one sleeve and one particular accessory kit consisting of seals and snap rings.
CFR Sort Flex-Rigid Couplings
The CFR Form coupling include 1 flex hub, one particular rigid hub, one particular sleeve, 1 accessory kit consisting of seals and snap rings.
Simple and affordable kind of gear coupling
All steel sleves and hubs
Reinforced rubber seals with snap rings to hold lubricant in area
Available as vertical and horizontal couplings
Broad selection of special variations like full-flex, flex-rigid mill motor
Common configurations are available in the shelf
Ordering Information
Application: Driver and Driven.
Variety and dimension of coupling, horizontal, vertical and so on.
Electrical power: Motor horspower or torque requirement.
Velocity: Motor RPM or Driven RPM.
Distance in between shaft ends (BSE).
Shaft sizes.
C and CFR Type Couplings
Ordering Details
Puller Holes are standard on sizes 4 by means of 12.
Puller Holes can be found for sizes 7/8 as a result of 3.5 at an additional charge.
The BSE (distance Amongst Shaft Ends) may fluctuate among G and G1.
Interference bores without any set screws are standard unless otherwise specified.
Inch bores and keyway tolerances conform to ANSI / AGMA 9002-B04.
For metric bores and keyway tolerances, check with Engineering Part.
Greater sizes are available, please consult Technical Support.